Installing Glue Sticks
1. Insert the glue stick into the glue stick inlet.
2. Squeeze the flow control trigger multiple times to push the glue stick
further down the channel.
WARNING!
IN THE EVENT OF ACCIDENTAL SKIN
CONTACT WITH HOT GLUE, RUN UNDER COLD
WATER IMMEDIATELY.
WARNING!
DO NOT ALLOW HOT GLUE TO COME
INTO CONTACT WITH THE PRODUCT HOUSING
DURING USE.
Installing A Different Nozzle
The nozzles on this glue gun can be changed to better suit the task at hand.
1. Remove the rubber nozzle cover by pulling it off the glue gun.
Note:
The nozzle cover may be difficult to remove after the glue gun has
been used. The spanner may be used to help remove it.
2. Unscrew the nozzle by turning it anti-clockwise with the 13mm spanner.
Note:
Inspect the rubber O-ring on the nozzle for damage before fitting it.
If the O-ring is worn, replace it before continuing to use the nozzle.
3. Fit the desired nozzle onto the end of the glue gun and tighten it by
turning it clockwise.
4. Fit the nozzle cover back onto the new nozzle.
2. CHANGING NOZZLES
3. LOADING GLUE STICKS
a.
b.
WARNING!
ENSURE THE TOOL IS SWITCHED OFF,
THE BATTERY IS REMOVED & THE TOOL HAS
COOLED DOWN BEFORE PERFORMING ANY OF THE
FOLLOWING TASKS.
