background image

BATTERY AND CHARGER SAFETY WARNINGS

THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS FOR YOUR 
BATTERY CHARGER.

1. 

Before using the charger read all instructions and cautionary markings on the charger, battery pack and the product 

using the battery pack.

2. 

This charger is not intended for any uses other than charging rechargeable batteries. Any other use may result in risk of 

fire, electric shock or electrocution.

3. 

Do not place any object on top of the charger or place the charger on a soft surface that may result in excessive internal 

heat. Place the charger in a position away from any heat source.

4. 

To reduce risk of damage to the electric plug and cord, pull by the plug rather than the cord when disconnecting the 

charger.

5. 

Make sure the cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

6. 

An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could result in the risk 

of fire, electric shock or electrocution.

7. 

Do not operate the charger if it has received a sharp blow, been dropped or otherwise damaged in any way. Have it 

checked by an electrician or power tool repairer.

8. 

Do not disassemble charger. Take it to an electrician or power tool repairer when service or repair is required. Incorrect 

reassembly may result in a risk of electric shock, electrocution or fire.

9. 

To reduce risk of electric shock, unplug the charger from the outlet before attempting any cleaning. Removing the 

battery pack will not reduce this risk.

10. 

Never attempt to connect 2 chargers together.

11. 

DO NOT store or use the tool and battery pack in locations where the temperature may reach or exceed 40ºC (such as inside 

sheds or metal buildings in summer).

12. 

The charger is designed to operate on standard household electrical power (240 volts). Do not attempt to use it on any 

other voltage!

13. 

The battery pack is not fully charged out of the carton. First read the safety instructions and then follow the charging 

notes and procedures.

14. 

The longest life and best performance can be obtained if the battery pack is charged when the air temperature is 

between 18 - 24ºC. Do not charge the battery pack in an air temperature below 10ºC or above 40ºC. This is important 

and will prevent damage to the battery pack.

15. 

Do not incinerate the battery pack even if it is seriously damaged or is completely worn out. The battery can explode in a 

fire.

16. 

Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack breaks or cracks, immediately 

discontinue use and do not recharge.

17. 

During charging, the battery must be placed in a well ventilated area.

DESCRIPTION OF SYMBOLS

Warning 

Read instruction manual

 ø

      

Diameter

      

 

mA

     

Milliamperes    

Recycle battery 

 

 

 

Do not put in the rubbish

Polarity

Do not incinerate   

 

 

Do not get battery wet

Thermal cut-out protection

Transformer Energy

Rating (MEPS)

Double insulated 

/min     

Revolutions or reciprocation per minute

Ah 

   

Amp hour

Indoor use only

Lithium Ion battery

Do not use or store battery in 

temperatures exceeding 50ºC

   

Regulatory Compliance 

Mark (RCM)

     

Nm     

Newton Meters   

 

n

o      

No load speed

  

V

 

    

Volts

 

 

 

            

Hz

      

Hertz

ac/~

      

Alternating current 

            

W

      

Watts

  

    

Direct current

 

 

dc/

SPARE PARTS

Spare parts can be ordered from the Special Orders 

Desk at your local Bunnings Warehouse. 
For further information, or any parts not listed here, 
visit www.ozito.com.au or contact Ozito Customer 
Service: 
Australia 1800 069 486 
New Zealand 0508 069 486 
E-mail: [email protected]

CARING FOR THE ENVIRONMENT

Power tools that are no longer usable should not be disposed of with 

household waste but in an environmentally friendly way. Please recycle 

where facilities exist. Check with your local council authority for recycling 

advice.

Recycling packaging reduces the need for landfill and raw materials. Reuse 

of recycled material decreases pollution in the environment. Please recycle 

packaging where facilities exist. Check with your local council authority for 

recycling advice.

Summary of Contents for PXDDGK-600





















Reviews: