MAINTENANCE
•
Keep ventilation slots of the trimmer clean at all times. Periodically clean out the
grass from the cutting head and the rim of the blade guard to ensure efficient
operation at all times.
•
After each use, blow air through the tool housing to ensure it is free from all
dust, dirt, etc. Build up of dust, dirt particles may cause the tool to overheat and
shorten the life of the tool.
•
If the housing of the trimmer requires cleaning, do not use solvents but a moist
soft cloth or soft brush only.
•
Never let any liquid get inside the tool, never immerse any part of the tool into
liquid.
• No lubrication is necessary as the tool has sealed bearings.
•
When not in use, the grass trimmer should be stored in a dry, frost free location
not within the reach of children.
WARNING!
ALWAYS ENSURE THE TOOL HAS
COMPLETELY STOPPED AND THE BATTERY IS REMOVED
PRIOR TO ANY MAINTENANCE.
Note: Ozito Industries will not be responsible for any damage or injuries caused
by the repair of the grass trimmer by an unauthorised person or by mishandling
of the grass trimmer. This tool is designed for DIY use - use in commercial or
industrial environments will void the warranty.
TRIMMING & EDGING
OPERATION
Trimming
Edging
Move the grass trimmer from side
to side as you walk forward, holding
it at an angle of approx. 30° (Light
cuts are better than heavy cuts as
they allow the cut grass to fall away
from the cutting head).
Place the edging guide along the
ground and slide the grass trimmer
along the edge of the path.
Battery protection system
The tool is equipped with the battery protection system, which helps to
ensure a long service life.
The output power automatically cuts off during operation when the tool and/
or battery are placed under the following situations:
• When the tool is overloaded:
If this occurs, release the trigger switch and remove causes of overload,
then pull the switch trigger again to restart.
• When the remaining battery capacity becomes low:
Recharge the battery pack.
Note:
The battery protection system does not in any way damage the tool.
Note:
The indicated capacity may be lower than the actual level during use
or immediately after using the tool.
30°
