Switching The Unit On/Off
1. Press the manual/auto trigger to
start the inflator; the display will
light up.
2. Press and hold the pressure mode button for 2
seconds. The tool and display will shut off.
Note:
The inflator will switch off automatically
after approximately 5 minutes of inactivity; the
display will also power down.
Presetting The Pressure
1. Press the pressure mode button
to toggle between the 3 pressure
units (bar, psi or kPa).
2. Increase the preset pressure using the “+”
button or decrease the pressure using the
“-” button.
The preset pressure will be displayed on
the digital display as it is adjusted.
Digital Display
The upper value on the screen shows
the preset pressure.
The lower value on the screen
displays the pressure of the
connected item as it is being
inflated.
Note:
If the connected item is already partially inflated, the existing
pressure will be registered on the display when connected.
WARNING!
DO NOT LEAVE UNATTENDED WHILST
THE TOOL IS IN OPERATION.
Installing The Battery Pack
1. Slide the battery into the tool
base until it clicks into place.
Removing The Battery Pack
1. Hold down the battery release
button and then slide the battery
out.
2. FITTING THE BATTERY
3. CONTROLS
OPERATION
MANUAL
AUTO
MANUAL
AUTO
PSI
KPA
BAR
-
+
BAR
PRESET
PRESSURE
CURRENT
PRESSURE
PSI
KPA
BAR
-
+
BAR
PSI
KPA
BAR
-
+
BAR
HOLD
PSI
KPA
BAR
-
+
BAR
MANUAL
AUTO