2. CONTROLS
OPERATION
Inserting & Removing the Battery
Variable Speed Trigger
Forward/Reverse Lever
1 Align the ribs of the battery with
the recess at the base of the
driver handle and push in until it
clicks into place.
3 Control the speed by adjusting the
amount of pressure applied to the
trigger.
2 To remove screws and bolts, push
the fwd/rev lever hard right.
2 To remove, press and
hold the battery release
tab and then slide out.
1 To start the driver, squeeze the
variable speed trigger.
2 Release the variable speed
trigger to stop the driver.
1 To drive screws and bolts, push
the fwd/rev lever hard left.
B
R
U
S
H
L
E
S
S
B
R
U
S
H
L
E
S
S
a
b
B
R
U
S
H
L
E
S
S
B
R
U
S
H
L
E
S
S
FWD
REV
B
R
U
S
H
L
E
S
S
B
R
U
S
H
L
E
S
S
Slower
Faster
Battery protection system
The tool is equipped with the battery protection system, which helps to ensure a long service
life.
The output power automatically cuts off during operation when the tool and/or battery are
placed under the following situations:
• When the tool is overloaded:
If this occurs, release the trigger switch and remove causes of overload, then pull the
switch trigger again to restart.
• When the remaining battery capacity becomes low:
Recharge the battery pack.
