3. DRIVING PROCEDURE
4. TROUBLESHOOTING
Note:
Do not force the driver or apply side pressure to elongate the hole.
Let the impact driver do the work.
2 Check the forward/reverse lever
is on desired setting.
5 Lightly squeeze the variable
speed trigger to start the driver.
1 Depress and release the on/off
trigger to ensure it is not locked.
4 Hold the driver firmly
against the fastener to
stop it slipping.
3 Ensure the work piece is secured
to stop it turning whilst driving.
6 Slowly increase pressure
on trigger to appropriate
torque for circumstances
until screw or bolt is
tightened.
B
R
U
S
H
L
E
S
S
FWD
REV
B
R
U
S
H
L
E
S
S
B
R
U
S
H
L
E
S
S
PXBIS-320
LED lights do not illuminate on charger
Check the charging adaptor is securely plugged into the wall out let.
Check the battery is firmly connected to the charging cradle.
Check that the charging jack is securely connected to the charging cradle.
The battery has a short run time
Ensure the battery is properly charged. It will take 4-5 charging cycles before the
battery reaches optimum charge and run time. On the initial charge, the battery
requires 5 hours of charging. Subsequent charging only requires 3-5 hours.
Variable speed trigger is locked
Ensure that the forward / reverse lever is in the correct position; pressed left for
forwards direction, pressed right for backwards direction. If it is in between the two
settings the variable speed trigger will be locked.
The Brushless Impact Driver is stripping the screw head
Ensure you are not applying to much force to the screw. Decrease the force by using a
slower trigger speed.
