PSDWV-500
4. SETUP
5. OPERATE
1. Ensure the outlet hose is connected correctly.
2. Ensure the distance from the surface of the water to the
highest point that you wish to deliver the water does not
exceed 8 metres.
WARNING!:
NEVER CARRY, LIFT OR PULL UP
THE PUMP BY THE POWER CORD. THIS WILL
DAMAGE THE UNIT.
WARNING!:
YOUR PUMP HAS THE CAPACITY
TO PUMP DIRTY WATER WITH A NON SOLID
PARTICLE SIZE OF UP TO 15MM IN DIAMETER.
1. Immerse the pump in the
water. For deep water,
use a rope (not included)
and secure it to the
handle. Set the pump
in the desired position
within the work area or
tank.
2. Insert the plug into the
mains power socket.
Where possible avoid
using extension cords
as this can lead to a
voltage drop which may
cause power loss and
overheating. Switch
on the mains power to
operate pump.
3. To stop operation, turn off the mains power. The pump
will also stop operation automatically once the float switch
reaches the minimum water depth.
Priming
When immersed and ON the pump will need to prime and
purge the air inside the pump before water flows at the
outlet. This can take up to 20 seconds. If operating the pump
manually tilting the pump to
allow some air to escape from
the base can help.
Air also escapes from the
Air Bleed Valve. When
pumping, the water
pressure will shut this valve
off.
WARNING!
THIS PUMP MUST BE USED WITH
RESIDUAL CURRENT DEVICE RATED 30mA OR
LESS.
Before starting, perform a few simple checks:
3. Adjust the float switch adjustor to allow the pump to switch on
and off at the desired water height.
4. Ensure that the container is large enough to allow the float
switch to move freely and function effectively, a minimum area
of 50x50x50cm is required.
5. Ensure the pump is placed on a flat and level surface, there
are no obstructions to the suction base and it is clear of mud
or sediment.
WARNING!:
THIS PRODUCT IS INTENDED
FOR PUMPING WATER IN A HOME DOMESTIC
APPLICATION. DO NOT USE IT FOR
CORROSIVE, ABRASIVE, EXPLOSIVE OR
DANGEROUS LIQUIDS.
MAX.
HEAD 8M
MAX.
IMMERSION
DEPTH 5M
DISCHARGE POINT
POWE
R
CAB
LE:
10M
WATER LEVEL
FLOAT
SWITCH
WATER CONTAINER
OUT
LET
HO
SE
OPERATION
WARNING!:
BEFORE SUBMERGING THE PUMP
IN WATER, UNWRAP THE POWER CORD AND
ENSURE THE PLUG IS CLEAR OF ANY DAMP
LOCATIONS.
WARNING!:
THE PUMP MUST NOT BE USED
WHEN PEOPLE ARE IN THE WATER.
