PRS-012
3. BATTERY AND CHARGING
4. CONTROLS AND OPERATION
OPERATION
WARNING!
THE POWER SUPPLY FOR THIS CHARGER
SHOULD BE PROTECTED BY A RESIDUAL CURRENT
DEVICE (RATED AT 30MA OR LESS). A RESIDUAL CURRENT
DEVICE REDUCES THE RISK OF ELECTRIC SHOCK.
Installing and Removing the Battery
Switching the Saw On and Off
Cutting Branches Using the Clamping Jaw
Cutting Without the Clamping Jaw
Charging the Battery
2 To remove, push the battery
release tabs on both sides of
the battery and then remove
from the tool.
2 Release the variable speed
trigger to stop the pruning saw.
2 Place the branch in between
the clamping jaws and then
lower to perform the cut.
2 Plug the charger into a power
socket and the red charging
light should illuminate.
1 Push the battery into
the battery seating
at the rear of the
pruning saw until it
clicks into place.
1 Push the safety
switch in from either
side of the tool
and then squeeze
the variable speed
trigger to start the
pruning saw.
1 Ensure the blade
and the clamping jaw
is secured correctly
and hold the saw
firmly.
1 Position the shoe
of the saw onto
the material to be
cut for stability and
then perform the
cut holding the saw
firmly.
When cutting thicker branches or sawing wood or plastic the clamping
jaws can be removed to prevent them getting in the way of the cut.
1 Place the battery
into the seating of
the charger.
3 Once the battery
is fully charged
the green light will
illuminate.
Note:
It will take 4-5 charging cycles before the battery reaches
optimum charge and run time.
