3. SDS+ ACCESSORY FITMENT
4. CONTROLS
OPERATION
Accessory
SDS+
1. Prior to inserting into chuck,
ensure the SDS+ accessory is
clear of dust and debris.
4. Rotate until accessory is inserted as
far as possible into locking sleeve.
5. Check SDS+ accessory is locked. Try
to pull it out. Note: It should have
approximately
10 – 20mm movement.
This is normal.
2. Prior to inserting into drill add
lubricant to the SDS+
accessory.
3. Insert SDS+ Accessory into
locking sleeve.
Note:
The locking sleeve
should not be pulled back when
inserting accessory.
6. To remove the SDS+ accessory pull
back the locking sleeve and pull
accessory out.
1. Choose an
operation mode:
Hammer Drill
Rotate the mode selector to the hammer and
drill icon. This setting is recommended for use
when drilling holes in concrete and other masonry
products. The hammer action will be in operation
while simultaneously the drill bit rotates.
Drilling
Rotate the mode selector to the drill icon. This
setting is recommended for use when you desire the
accessory to rotate without hammer action. Ideal for
drilling into timber or steel when correct accessories
for such materials are used.
NOTE:
PRIOR TO CHANGING MODES, THE VARIABLE
SPEED TRIGGER SHOULD BE RELEASED AND THE
DRILL SHOULD HAVE COME TO A COMPLETE STOP.
3
Mode selector
Note:
This product is not intended for driving
screws.
CAUTION:
TO REDUCE THE RISk OF INjURY
WE RECOMMEND THE USE OF GLOVES WHEN
HANDLING DRILL BITS.
WARNING!
Ensure the tool is turned off & battery removed before
performing any of the following operations.
