2. PREPARATION
1. Press and hold the lock-off
button, then pull the start/stop
lever towards the handle to
start the mower. Release the
lock-off button once the mower is
running.
2. Release the start/stop lever to
stop the mower.
To prevent accidental start up, the mower is fitted with a dual action switch.
Switching On and Off
Adjusting the Cutting Height
1
2
1
2
WARNING!
ONLY FIT AND REMOVE THE GRASS
CATCHER WHEN THE MOWER IS SWITCHED OFF
AND THE MOTOR HAS COME TO A STOP.
1. Locate cord on outside of
handle. Secure the power
cord from the switch housing
to the mower using the 3
cable clips.
Securing the Cord
Ensure the cord follows the
handle smoothly from the switch
to the body of the mower.
Grass Catcher Assembly
1. Push the catcher frame into
the grass catcher.
2. Snap the side fastening lugs on
the grass catcher over
the catcher frame.
3. Snap the bottom
fastening lug on the
grass catch over the
catcher frame.
The cutting heights can be set between a range of 14 – 38 mm in 4 intervals
and can be read off the scale. To obtain the desired cutting height, the left
and right height adjustment must be repositioned on the side of the mower
housing.
1. Changing the cutting height is
quick, easy and requires no tools.
Simply pull out the spring-loaded
height adjustment knob and
adjust until the required height is
selected. This enables the roller
assembly to slide up or down to
place the cutting bar at a different
height level.
2. Release height adjustment knob and check that it is securely seated in the
required cutting height position.
Note:
Set the cutting height so that the cutting bar does not touch the
ground if there is any uneven ground.
Note:
Make sure that left and right height adjustments are at the same
height.
Fitting the Grass Catcher
1. Hook the grass catcher in place
on the left and right side of the
roller.
2. Secure the catcher strap to the
lower handle, adjust so catcher
sits flat when mowing.
Note:
The ejector flap can be adjusted to a number of different settings for
the ejection of the grass to the grass catcher.
WARNING!
ONLY ADJUST THE CUTTING HEIGHT
WHEN THE MOWER IS SWITCHED OFF AND THE
MOTOR HAS COME TO A STOP.
WARNING!
THE BLADE CONTINUES TO ROTATE
FOR A FEW SECONDS AFTER THE MOTOR HAS
BEEN SWITCHED OFF. NEVER ATTEMPT TO MANUALLY
STOP THE BLADE.