2. PREPARATION
1. Open the battery cover. Slide two
batteries of the same capacity
and same charge state into the
mower aligning the ribs so that
they click into place.
2. Insert the safety key.
(If the mower is not going to be
used immediately, do not insert
the safety key.)
1. Lift up the grass catcher flap
with one hand and guide the
catcher with your other hand
over the two hooks on the
mower housing.
3. To remove, raise the grass catcher flap and lift the grass catcher out.
3. Close the battery cover.
2. Lower the grass catcher and
allow it to sit in place. Lower
the grass catcher flap.
Inserting the Batteries into the Mower
Adjusting the Cutting Height
Securing the Cord
WARNING!
ONLY FIT AND REMOVE THE CATCHER
WHEN THE MOWER IS SWITCHED OFF AND THE
MOTOR HAS COME TO A STOP.
NOTE:
The grass catcher flap
is held against the grass catcher
by a spring.
The cutting height adjustment lever provides 9 cutting heights from 25mm -
80mm.
1. Pull lever outwards away from
the mower body.
2. Adjust until the required
cutting height is selected.
3. Release lever and check
that it is securely seated in
the required cutting height
position.
Only use 2 batteries with the same capacity. For best performance use 3.0Ah
batteries and above. Always use 2 batteries with the same charge state with
the mower.
WARNING!
WHEN FITTING THE GRASS CATCHER
AFTER EMPTYING, ALWAYS ENSURE THERE IS NO
BUILD UP OF GRASS IN THE GRASS CHUTE.
Grass Catcher Indicator
The grass catcher is fitted with an
indicator at the rear of the catcher to
help identify when to empty.
When in operation the indicator floats
up when the catcher is empty. If the
indicator drops down then the grass
catcher is full and needs emptying.
WARNING!
ENSURE THE TOOL IS SWITCHED OFF
AND BATTERIES ARE DISCONNECTED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
Fitting and Removing the Grass Catcher
Ensure the cord follows the inside
of the handles smoothly from the
switch to the body of the mower.
1. Place the supplied cord clips
over the cord. Push the cord
clip onto the handle to secure
in place.
WARNING!
ALWAYS ENSURE THE KEY IS REMOVED
WHEN NOT IN USE.
