Short Battery Runtime
Ensure the battery is properly charged. It will take 4-5 charging cycles
before the battery reaches optimum charge and run time.
Battery protection system
The tool is equipped with the battery protection system, which helps to
ensure a long service life.
The output power automatically cuts off during operation when the tool
and/or battery are placed under the following situations:
• When the tool is overloaded:
If this occurs, release the trigger switch and remove causes of
overload, then pull the switch trigger again to restart.
• When the remaining battery capacity becomes low:
Recharge the battery pack.
Note:
The battery protection system does not in any way damage the tool.
Note:
The indicated capacity may be lower than the actual level during
use or immediately after using the tool.
Worklight does not turn on
The worklight only illuminates once the lock-off button is pressed to either
side of the handle.
Ensure that the light source is not covered in dust. Use a dry cloth to wipe
away dust.
7. TROUBLESHOOTING
1. Always hold the rear handle with
one hand and the front handle
with the other.
2. Maintain a firm grip and operate the on/off switch with a positive action.
3. Never force the saw; use light and continuous pressure.
4. When cutting is interrupted, do not restart the tool in the middle of the
cut/workpiece. Remove the blade from the cut, restart the tool and allow
the blade to reach steady speed before slowly and steadily re-entering
the cut and resuming.
5. When cutting across the grain, the fibres of the wood have a tendency to
tear and lift. Advancing the saw slowly minimises this effect.
6. For a finer finish cut, a cross cut blade or mitre blade is recommended.
6. USAGE TIPS
RIGHT HANDED SAW
THIS SIDE OUT
24
184
MM
TOOTH
Max. Speed 9500rpm
Bore: 20mm
Thickness: 1.6mm
TUNGSTEN
CARBIDE
TEETH
(7¼”)
WARNING!
Do not use tungsten carbide tipped blades for
masonry or metal cutting applications.
