CARING FOR THE ENVIRONMENT
Tools that are no longer usable should not be disposed of with
household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council
authority for recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution in the
environment. Please recycle packaging where facilities exist.
Check with your local council authority for recycling advice.
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito customer service
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
DESCRIPTION OF SYMBOLS
cc
Cubic Centimeters
n
o
No load speed
/min
Revolutions or reciprocation per minute
dB
Decibel level
Read the manual prior to use
Wear safety boots
Wear safety gloves
Warning
Pull recoil starter to start motor
40:1 Fuel Oil mix ratio
Choke control on
Keep bystanders away
Keep bystanders away
Thrown objects can cause
severe injury.
Extremely hot surface.
110
Sound pressure level
Don’t use metal blades
Wear safety glasses
Wear muffs
Do not expose to rain
Choke control off
Electrical Emissions Comformity (EMC)
Do not smoke.
TROUBLESHOOTING
FAULT
POSSIBLE CAUSES
TROUBLESHOOTING
The
machine
does not
start.
Correct starting procedure not
followed.
Follow the instructions
for starting.
Dirty or old fuel mix.
Replace with clean fuel mix.
Dirty spark plug.
Clean the spark plug and
adjust the electrode gap or
fit a new spark plug.
Incorrect carburettor setting.
Contact an authorized
customer service outlet.
The
machine
starts but
does not
develop its
full output.
Incorrect choke lever setting.
Set choke lever to “ ”
Dirty or clogged air filter.
Clean the air filter.
Incorrect carburettor setting.
Contact an authorized
customer service outlet.
The engine
does
not run
smoothly
Incorrect electrode gap on the
spark plug.
Clean the spark plug and
adjust the electrode gap or
fit a new spark plug.
Incorrect carburettor setting.
Contact an authorized
customer service outlet.
Engine
smokes
excessively
Incorrect fuel mix.
Use 40 parts fuel to
1 part oil mix.
Incorrect carburettor setting
Contact an authorized
customer service outlet.
Cleaning
• We recommend that you clean the device each time that you have
finished using it, with a moist cloth and some soft soap . Do not use
cleaning agents or solvents; these could attack the plastic parts of
the line trimmer. Ensure that no water seeps into the device. Keep all
safety devices, air vents and the motor housing free of dirt and dust as
far as possible.
Storage (long term)
In order to avoid deposits forming on the interior of the carburettor, follow
these instructions:
1. Carry out all of the maintenance work and drain the fuel out of the tank.
2. When the fuel has been drained, start the engine and allow it to run at
idling speed until it stops. This will clean the remainder of the fuel out
of the carburettor.
3. Leave the machine to cool (approx. 5 minutes).
4. Remove the spark plug.
5. Place a teaspoon full of 2-stroke engine oil into the combustion
chamber. Pull the recoil starter several times carefully to wet the
internal components with the oil. Fit the spark plug again.
6. Store the machine in a cold, dry place where it is out of the reach of
ignition sources and inflammable substances.
