1
2. FUEL
WARNING!:
PETROL IS VERY FLAMMABLE. AVOID
SMOKING OR CAUSING ANY SPARKS OR FLAMES
NEAR FUEL. MAKE SURE THAT YOU STOP THE MOTOR
AND ALLOW IT TO COOL BEFORE REFUELLING THE
PETROL EDGER. SELECT AN OPEN OUTDOOR AREA
FOR FUELLING AND MOVE AT LEAST 3M AWAY FROM
THE FUELLING POINT BEFORE STARTING THE MOTOR.
Motor fuel: mix at 40:1 only
Note.
Only use oil that is expressly labelled for use with air-cooled
2-stroke engines.
Note.
Always transport and store fuels in an
approved container (supplied bottle is for mixing
only).
1. Fill with unleaded petrol (91 octane) up
to fuel line.
2. Add 2-stroke oil up to oil line. Shake
sufficiently for a thorough mix.
3. Fill the fuel tank to about 80% of its capacity
with the fuel mix.
Fuel tank capacity: 500ml
4. Fasten the fuel tank cap and
clean any spillage.
The edger has a height adjustment lever to easily adjust the cutting
height.
There are 5 height settings ranging between 8 – 45mm.
1. To decrease the cutting
height pull the height
adjustment lever out
and move it up a notch,
towards the handlebar.
2. To increase the cutting
height pull the height
adjustment lever out
and move it down a
notch, towards the front
of the unit.
Note.
If you are unsure of
which cutting height to use,
begin with a high setting
and complete a trial cut on a
small section of the lawns edge.
Readjust if necessary.
500ml
Regular
Unleaded
3. ADJUSTING CUTTING DEPTH
WARNING!:
NEVER ATTEMPT TO FUEL THE EDGER
IF THE FUEL SYSTEM COMPONENTS ARE
DAMAGED OR ARE LEAKING.
WARNING!:
ALLOW THE ENGINE TO COOL BEFORE
FUELLING. NEVER ATTEMPT TO REFUEL THE
ENGINE WHILE IT IS WARM OR STILL RUNNING.
WARNING!:
NEVER PLACE FLAMMABLE MATERIAL
CLOSE TO THE ENGINE MUFFLER.
