MAINTENANCE
TROUBLESHOOTING
• If the supply cord of this power tool is damaged, it must be replaced by a specially
prepared cord available through the service organisation.
• Keep the ventilation vents of the circular saw clean at all times, if possible, prevent
foreign matter from entering the vents.
• After each use, blow air through the circular saw housing to ensure it is free from all
dust particles which may build up. Build up of dust particles may cause the circular
saw to overheat and fail.
• If the enclosure of the circular saw requires cleaning, do not use solvents but a
moist soft cloth only. Never let any liquid get inside the circular saw; never immerse
any part of the circular saw into a liquid.
Carbon Brushes
When the carbon brushes wear out, the circular saw will spark and/or stop.
Discontinue use as soon as this happens. They should be replaced prior to
recommencing use of the circular saw. Carbon brushes are a wearing component of
the circular saw therefore not covered under warranty. Continuing to use the circular
saw when carbon brushes need to be replaced may cause permanent damage to
the circular saw. Carbon brushes will wear out after many uses but when the carbon
brushes need to be replaced, take the circular saw to an
electrician or a power tool repairer for a quick and low
cost replacement. Always replace both carbon brushes at
the same time.
Note: Ozito Industries will not be responsible for any
damage or injuries caused by the repair of the circular
saw by an unauthorised person or by mishandling of the
circular saw.
Replacing the Drive Belt
If the drive belt wears out, the belt will have to be replaced. Drive belts are a wearing
component of the mini circular saw therefore not covered under warranty. The drive
belt will wear out after many uses but when the belt need to be replaced, take the
saw to an electrician or a power tool repairer for a quick and low cost replacement.
Sparking visible through the housing air vents
A small amount of sparking may be visible through the housing vents.
This is normal and does not indicate a problem.
Excessive sparking visible through the housing air vents
and/or the circular saw failing to operate
May indicate the carbon brushes have worn out and need to be
replaced. Carbon brushes should only be replaced by a qualified
electrician or power tool repairer.
SPARE PARTS
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse or Homebase store.
For further information, or any parts visit
www.ozito-diy.co.uk or contact Ozito Customer Service:
Great Britain: 0151 294 4488
Ireland: 1850 882711
E-mail: [email protected]
DESCRIPTION OF SYMBOLS
V
Volts
Hz
Hertz
~
Alternating current
W
Watts
/min
Revolutions or
reciprocation per minute
Double insulated
n
Max rated speed
Warning
Read instruction manual
Wear eye protection
Wear gloves
ø
Diameter
Wear ear, eye and
respiratory protection