ADDITIONAL SAFETY RULES FOR CUTTING SAW
•
Recommendation for the use of a residual current device
with a rated residual
current device of 30mA or less for extra protection against electric shock.
•
Make sure that the cutting blade is correctly screened by the guard.
•
Never remove the riving knife. The distance between the cutting blade and the
riving knife should not exceed 5mm.
•
Do not use cutting blade which is bent, deformed or otherwise damaged.
•
Do not use cutting blade which do not comply with the specifications stated in
this manual.
•
Never start cutting tiles before the machine reaches full speed.
•
Never attempt to cut extremely small workpiece.
•
Do not leave the work area until the machine has been switched off and the
cutting disc has come to a complete standstill.
•
Never attempt to stop the cutting blade by exerting pressure on the side of the blade.
•
Always unplug the machine before performing any maintenance.
•
Do not use the machine before it has been completely assembled and installed
according th the instructions.
•
Do not perform any design, assembly or construction activities on the table while
the machine is switched on.
•
Unplug the machine and clean the table before leaving the work area.
Position of tile saw
1. To avoid the possibility of the appliance plug or
powerpoint getting wet, position tile saw to one
side of a wall mounted powerpoint to prevent
water from dripping onto the powerpoint or
plug. The user should arrange a "drip loop" in
the cord connecting the saw to a powerpoint.
The "drip loop" is that part of the cord below
the level of the powerpoint, or the connector if
an extension cord is used, to prevent water
travelling along the cord and coming in contact
with the powerpoint.
2. If water is present, have an electrician complete any necessary work or repairs. DO
NOT ATTEMPT ANY REPAIRS YOURSELF.
Mounting the machine
It is recommended that the machine be screwed to a workbench.
•
Mark the position of the mounting holes (2) on the workbench.
•
Drill holes at each of the marked positions, adjusting the diameter and depth of
the holes to the screws used.
•
Place the machine on the workbench and insert the screws into the mounting holes.
•
Firmly tighten the screws.
OPERATION
7
Tool
Power Supply Cord
Supporting
Surface
Drip Loop
!!
