8
V
Volts
Hz
Hertz
~
Alternating current
W
Watts
/min
Revolutions or
reciprocation per minute
Double insulated
Regulator compliance mark
n
o
No load speed
TOOL OPERATION (cont.)
1. Load the staples/nails to the magazine as previously described.
2. Connect the tool to a power supply.
3. Push the power switch (2) to the "l" position.
4. Hold the tool firmly against the work surface with the nosepiece of the tool at
the place where you want the staple/nail to be located. The staple/nail will exit
the tool just behind the safety striker pin (7).
5. Push the tool firmly down on the work surface to depress the safety striker pin (7).
Pull the trigger switch (1).
6. When finished using the tool, turn the power switch (2) to the '0' setting.
Disconnect the tool from the power supply and remove any remaining
staples/nails.
•
If necessary you can clean the staple/nail gun with a damp cloth. Do not use
cleaning agents or solvents as these can damage the plastic components of
the tool.
Note:
Ozito Industries will not be responsible for any damage or injuries caused
by the repair of the staple/nail gun by an unauthorised person or by mishandling
of the tool.
MAINTENANCE
DESCRIPTION OF SYMBOLS