9
OPERATION (cont.)
Hammer Drilling Mode
This setting is recommended for use when drilling holes in concrete and
other masonry products. The hammer action will be in operation while the
drill bit rotates simultaneously.
To engage this mode rotate the mode selector on the top of the drill to the
hammer and drill icon, and rotate the rear mode selector to the drill and
hammer icon as shown below.
Chiselling
This setting is recommended for use when you desire a hammer action
without the accessory rotating which is ideal for “chiselling or chipping” away
at masonry products, pick or chisel accessory bits should be used.
To engage this mode rotate the mode selector on top of the drill to the
hammer icon, and rotate the rear mode selector to the drill and hammer icon
as shown below.
Drilling
This setting is recommended for use when you desire the accessory to rotate
without hammer action. Ideal for drilling into timber or steel when correct
accessories for such materials are used.
To engage this mode rotate the mode selector on top of the drill to the
hammer and drill icon, and rotate the rear mode selector to the drill icon.
