3
INTRODUCTION
SAFETY INSTRUCTIONS
ELECTRICAL SAFETY
Congratulations on purchasing an Ozito Rotary Hammer Drill.
We aim to provide quality tools at an affordable price.
We hope you will enjoy using this tool for many years.
Your Ozito Rotary Hammer Drill OZRH1100A has been
designed for drilling, chiselling & chipping masonry products,
it can also drill timber and steel using the chuck adaptor
included. It is intended for DIY use only.
Warning!
When using mains-powered equipment, basic safety
precautions, including the following, should always be followed to
reduce risk of fire, electric shock, personal injury and material damage.
Read and understand the manual prior to operating this tool.
Save these instructions and other documents supplied with this tool for
future reference.
The electric motor has been designed for 230V and 240V only. Always check
that the power supply corresponds to the voltage on the rating plate.
Note:
The supply of 230V and 240V on Ozito tools are interchangeable for
Australia and New Zealand.
This tool is double insulated in accordance with AS
60745.2.6
;
therefore no earth wire is required.
If the supply cord is damaged, it must be replaced by the manufacturer
or an authorised Ozito Service Centre in order to avoid a hazard.
Note:
Double insulation does not take the place of normal safety
precautions when operating this tool. The insulation system is for added
protection against injury resulting from a possible electrical insulation failure
within the tool.
Using an Extension Lead
Always use an approved extension lead suitable for the power input of this
tool. Before use, inspect the extension lead for signs of damage, wear and
ageing. Replace the extension lead if damaged or defective.
When using an extension lead on a reel, always unwind the lead completely.
Use of an extension lead not suitable for the power input of the tool or which
is damaged or defective may result in a risk of fire and electric shock.
