MAINTENANCE
11
• Keep the ventilation vents of the tool clean at all times, if possible, prevent
foreign matter from entering the vents.
• After each use, blow air through the tool housing to ensure it is free from all
dust particles which may build up. Build up of dust particles may cause the tool
to overheat and fail.
• If the enclosure of the tool requires cleaning do not use solvents but a moist
soft cloth only. Never let any liquid get inside the tool; never immerse any part
of the tool into a liquid.
Carbon brushes
When the carbon brushes wear out the tool will spark and/or
stop. Discontinue use as soon as this happens. They should
be replaced prior to recommencing use of the tool. Carbon
brushes are a wearing component of the tool therefore not
covered under warranty. Continuing to use the tool when
carbon brushes need to be replaced may cause permanent
damage to the tool. Carbon brushes will wear out after many uses but when
the carbon brushes need to be replaced take the tool to an electrician or a power
tool repairer for a quick and low cost replacement. Always replace both carbon
brushes at the same time.
Note:
Ozito Industries will not be responsible for any damage or injuries caused
by the repair of the tool by an unauthorised person or by mishandling of the tool.
Limited spare parts are available subject to availability. Please contact your local
Bunnings Special Orders Desk to order the required spare parts.
Most common spare parts listed below
Spare Part
Part No.
Blade Clamp
SPOZJS750WB-09
Screw M5x10
SPOZJS750WB-12
Carbon Brushes (set)
SPOZJS750WB-33
Switch Assembly
SPOZJS750WB-42
SPARE PARTS
