![background image](http://html.mh-extra.com/html/ozito/ozhg2000wak/ozhg2000wak_instruction-manual_1666597004.webp)
4
INTRODUCTION
Congratulations on purchasing an Ozito Heat Gun. We aim to
provide quality tools at an affordable price. We hope you will
enjoy using this appliance for many years.
Your Heat Gun OZHG2000WAK has been designed for stripping
paint, warm heat shrinking and virtually to perform any task
where hot air is required. It is intended for DIY use only.
Warning!
When using mains-powered equipment, basic safety precautions,
including the following, should always be followed to reduce risk of fire,
electric shock, personal injury and material damage.
Read and understand the manual prior to operating this tool.
Save these instructions and other documents supplied with this tool for future reference.
The electric motor has been designed for 230V and 240V only. Always check that the
power supply corresponds to the voltage on the rating plate.
Note:
The supply of 230V and 240V on Ozito tools are interchangeable for Australia
and New Zealand.
If the supply cord is damaged, it must be replaced by an electrician or a power tool
repairer in order to avoid a hazard.
This tool is double insulated in accordance with AS/NZS60335; therefore no
earth wire is required.
Note:
Double insulation does not take the place of normal safety precautions when
operating this tool. The insulation system is for added protection against injury
resulting from a possible electrical insulation failure within the tool.
Using an Extension Lead
Always use an approved extension lead suitable for the power input of this tool. Before
use, inspect the extension lead for signs of damage, wear and ageing. Replace the
extension lead if damaged or defective.
When using an extension lead on a reel, always unwind the lead completely. Use of an
extension lead not suitable for the power input of the tool or which is damaged or
defective may result in a risk of fire and/or electric shock.
!!
ELECTRICAL SAFETY
!!