Replacing the spool & line (14)
Important! Make sure that
you unplug the battery
pack (3) before replacing
the spool & line (14) (Fig. 9)!
• Press the sides of the
spool cover as shown
and remove it with the
spool (Figure 9+10).
Ensure that you do not
lose the spring.
• Remove the empty spool.
• Thread the ends of the line on the new spool
through the eyelets in the spoolcover (Fig. 11).
• Fit the spring, spool and spool cover back into the
spool mounting (Fig.10).
• Ensure that the blade cover is removed from the
cutting guard (12).
• The line will be cut to the correct length when the
cutting head starts up again.
Manually re-winding spool with nylon line
• Remove the empty spool and do not lose
the spring.
• Remove the retaining strap from the spool (Fig.12).
• Cut a length of nylon line 8m long (max.) and fold
in half.
• Insert the 2 ends of the nylon line into 2 holes of
the spool (Fig.13).
• Replace the retaining strap on the spool (Fig.14)
ensuring each half of the nylon line is located in
each of the slots on the retaining strap.
• Thread the nylon line through the holes in the
spool and pull the 2 halves completely through
the holes.
• Hold the spool and line on a flat surface or in the
palm of your hand with the bump knob pointing
towards the sky or ceiling.
OPERATION (cont.)
12
Fig. 9
Fig. 10
Fig. 11
Fig.12
Fig.13
Fig.14
