MAINTENANCE cont.
DESCRIPTION OF SYMBOLS
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
BATTERY AND CHARGER SAFETY WARNINGS
THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS FOR YOUR
BATTERY CHARGER.
1.
Before using the charger read all instructions and cautionary markings on the charger, battery
pack and the product using the battery pack.
2.
This charger is not intended for any uses other than charging rechargeable batteries. Any other
use may result in risk of fire, electric shock or electrocution.
3.
Do not place any object on top of the charger or place the charger on a soft surface that may
result in excessive internal heat. Place the charger in a position away from any heat source.
4.
To reduce risk of damage to the electric plug and cord, pull by the plug rather than the cord when
disconnecting the charger.
5.
Make sure the cord is located so that it will not be stepped on, tripped over, or otherwise sub-
jected to damage or stress.
6.
An extension cord should not be used unless absolutely necessary. Use of an improper extension
cord could result in the risk of fire, electric shock or electrocution.
7.
Do not operate the charger if it has received a sharp blow, been dropped or otherwise damaged
in any way. Have it checked by an electrician or power tool repairer.
8.
Do not disassemble charger. Take it to an electrician or power tool repairer when service or
repair is required. Incorrect reassembly may result in a risk of electric shock, electrocution or fire.
9.
To reduce risk of electric shock, unplug the charger from the outlet before attempting any clean-
ing. Removing the battery pack will not reduce this risk.
10.
Never attempt to connect 2 chargers together.
11.
DO NOT store or use the tool and battery pack in locations where the temperature may reach or
exceed 40ºC (such as inside sheds or metal buildings in summer).
12.
The charger is designed to operate on standard household electrical power (240 volts). Do not
attempt to use it on any other voltage!
13.
The battery pack is not fully charged out of the carton. First read the safety instructions and then
follow the charging notes and procedures.
14.
The longest life and best performance can be obtained if the battery pack is charged when the
air temperature is between 18 - 24ºC. Do not charge the battery pack in an air temperature
below 10ºC or above 40ºC. This is important and will prevent damage to the battery pack.
15.
Do not incinerate the battery pack even if it is seriously damaged or is completely worn out. The
battery can explode in a fire.
16.
Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack
breaks or cracks, immediately discontinue use and do not recharge.
17.
During charging, the battery must be placed in a well ventilated area.
Warning
Read instruction manual
Wear eye protection
Double insulated
/min Revolutions or
reciprocation per minute
n
0
No load speed
V
Volts
Hz
Hertz
~
Alternating current
W
Watts
Diameter
Regulator compliance mark
milliamp hour
mm
Millimetres
Indoor use only
Ah
Amp hour
mAh
mA
milliamp
dc
Direct current
Transformer Energy
Rating (MEPS)
Thermal cut-out protection
“CLICK”
Changing the Blade
CAUTION!
DO NOT HANDLE BLADES WITHOUT GLOVES
AS THEY ARE SHARP AND CAN BECOME HOT AFTER
USE, POTENTIALLY CAUSING PERSONAL INJURY.
1. To unlock and remove
the cutting blade, rotate
the blade lock clockwise.
2. Carefully pull the cutting blade away from the pruner.
3. Insert the new cutting blade into position.
4. Lock the new cutting blade into
position by rotating the blade
lock anti-clockwise, you will
hear a “CLICK” that indicates
the blade is locked in position.
“CLICK”
“CLICK”
Note:
Ozito Industries will not be responsible for any damage or
injuries caused by repair of the pruner by an unauthorised person or by
mishandling.
• If the housing of the pruner requires cleaning, do not use
solvents. Use of a cloth only is recommended.
STORAGE
• When not in use, the tool should be stored in a dry, frost free
location, keep out of children’s reach.
• When the tool will not be used for several months fully
charge the battery.
• Make sure that the blade lock
is in the lock position, then
assembly the blade cover over
the blades.
