MFS-4000
5. DRILL BIT SHARPENER
4. SHARPENING SCISSORS
1 Install the knife and scissor
sharpener module.
1 Install the drill bit sharpener
module.
3 Place the clamp assembly
with the drill bit into the
“V” guide by locating the
grooves on the side.
5 Tighten the clamp assembly
to secure the drill bit in
position and then remove
the clamp assembly.
7 Switch the sharpener on
and move the upper section
of the module from side to
side with light pressure.
3 Open the scissors
completely and position
so that the bevelled
cutting edges is facing the
sharpening wheel.
5 Draw the blade across the
sharpening wheel from the
pivot to the tip using light
steady pressure.
7 Repeat until clean, sharp edges are obtained.
Note:
Before sharpening any scissors make sure that they are
suitable for sharpening. Most exchangeable blade scissors are not
suitable for sharpening.
2 Switch the sharpener on by
pressing the on/off switch
into the on position “I”.
2 Remove the clamp
assembly and insert a
drill bit. Tighten the clamp
assembly lightly so that the
drill bit can still move.
4 Rotate the drill bit while
pushing the “V” guide onto
the drill bit until all 4 drill
tips touch the “V” guide.
6 Insert the clamp assembly
and drill bit into the module
central locating slot.
6 Remove the clamp
assembly, rotate the drill bit
180° and repeat steps 4-7
for the opposite side.
4 Slide one blade of the
scissors through the scissor
sharpening slot.
6 Remove the scissor and
turn over to sharpen the
second blade.
a
b
0
I I
I
a
b
180
0
