DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
TROUBLESHOOTING
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
• Keep ventilation slots of the trimmer clean at all times. Periodically clean out
the grass from the cutting head and the rim of the safety guard to ensure efficient
operation at all times.
• After each use, blow air through the tool housing to ensure it is free from all dust,
dirt, etc. Build up of dust, dirt particles may cause the tool to overheat and shorten
the life of the tool.
• If the housing of the trimmer requires cleaning, do not use solvents but a moist
soft cloth or soft brush only.
• Never let any liquid get inside the tool, never immerse any part of the tool into
liquid.
• No lubrication is necessary as the tool has sealed bearings.
• When not in use, the line trimmer should be stored in a dry, frost free location not
within the reach of children.
Note: Ozito Industries will not be responsible for any damage or injuries caused
by the repair of the line trimmer by an unauthorised person or by mishandling of
the line trimmer. This tool is designed for DIY use - use in commercial or industrial
environments will void the warranty.
Spool Cover (Pkt 2)
LTSCA-301
Spool & Line
ACCLT-005
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
V
Volts
Hz
~
Alternating current
W
/min
Revolutions or
reciprocation per minute
Double insulated
n
o
Warning
Wear eye protection
Regulator compliance mark
Read instruction manual
Keep bystanders away
Disconnect the mains plug
if the cord is damaged
or entangled
Decibel level
Do not operate in the rain
Keep bystanders away
Hertz
Watts
No load speed
96
dB
Problem
Cause
Remedy
Grass wraps
around the
attachment shaft
and the trimmer
head.
Cutting tall grass
at ground level.
Make several passes from
top down.
Rewinding spool from a bulk line
Bulk line for your line trimmer is available from your local dealer.
To install, follow steps:
1 Remove the spool as described in steps 1 - 3 of the
“Replacing the
spool/clearing jams and tangled lines”
section.
2 Cut a length of line approximately 10m long. Divide the line evenly so
you find the half-way point and cut in half.
3 Make a small loop, approximately 15mm
on one end of each line. Place each end
of the cutting line through the hole in the
spool to lock it in place.
4 Wind the cutting line onto the spool in
the direction of the arrow. Make sure to
wind the line on neatly and in layers. Do
not cross the line as this will stop it from
feeding.
5 When the length of line is wound onto
the spool place the end of the line into
the clips in the outside of the spool.
Leaving about 15cm protruding from the
spool
6 Re-seat the spool as described in steps 4 - 7 of the
“Replacing the
spool/clearing jams and tangled lines”
section.
