2. CHARGING STAND
3. BATTERY & CONTROLS
OPERATION
Variable Speed Controls
Installing and Removing the Battery
1 To increase the speed
of the tool, press the “+”
variable speed button.
2 To decrease the speed
of the tool, press the “-”
variable speed button.
1 Slide the battery into the tool
until it clicks into place.
2 To remove, please the battery
release button and then slide
out of the tool.
1
2
3
4
5
Note:
Once fully charged, all green lights will be illuminated.
WARNING!
THE POWER SUPPLY FOR THIS CHARGER IS
RECOMMENDED FOR USE WITH A RESIDUAL CURRENT
DEVICE (RATED AT 30mA OR LESS).
Charging the Battery Using the Charging Stand
Charging a USB Device
2 Slide the battery onto the
cradle. The first 2 lights will
illuminate when battery is
properly connected and is
charging.
2 To start charging the USB
device, press the power button
on the charging cradle.
1 Plug charging
jack into the fast
charging cradle.
The first green
light will illuminate
when connected.
1 While connected
to power, USB
devices can be
plugged into the
front of the cradle
for charging.
On/Off Switch
1 To start the tool, push the on/
off switch forward, into the on
position.
2 To stop the tool, push the on/
off switch backward, into the
off position.
Note:
Once fully charged, the green LED light will be illuminated.
Charging the Battery Directly
2 The red LED light will
illuminate while charging.
1 Plug charging jack
directly into the
top of the battery
