!!
To Adjust Torque
•
Locate the arrow on the front of the drill housing (see Fig. 6).
•
Identify the torque settings and 1 drill setting on the torque
adjustment collar (2).
•
Rotate the torque adjustment collar (2) to the desired setting,
aligning the required number on the torque adjustment collar
(2) with the arrow on the drill housing.
•
To increase or decrease torque, rotate the torque adjustment
collar (2). The lower the number, the lower the torque setting.
The higher the number, the higher the torque setting.
Always check that the correct torque is selected by practising on scrap material prior to
carrying out a job.
The torque setting required to drive screws will differ with different materials. Start with
the torque setting on the number you think is appropriate (Eg: 4) and simply increase
the torque adjustment collar to a higher number if the screw head is not sitting flush
with your workpiece. Remove the screw after adjusting and re-drive the screw back into
the workpiece until the correct torque adjustment leaves the screw head flush with
your workpiece.
Keyless Chuck
A keyless chuck (1) is included on your drill to allow for
easy installation and removal of bits/accessories.
To open and close the keyless chuck (1), rotate the chuck
body with your other hand (see Fig. 7).
The arrows on the chuck indicate in which direction to
rotate the chuck body in order to GRIP (tighten) or
RELEASE (unlock) the drill bit.
Warning!
Do not hold the chuck body with one hand and use power of the
drill to tighten or loosen the chuck jaws. The chuck body could slip and your
hand could come in contact with a rotating accessory. This could cause an
accident resulting in personal injury.
Installing Drill or Driver Bits
•
Remove the battery (5) from the drill.
•
Open or close the keyless chuck (1) to a point where
the opening is slightly larger than the drill or driver bit
you intend to use.
•
Insert the drill or driver bit into the keyless chuck (1),
ensuring the end of the drill or driver bit does not
touch the screw inside the keyless chuck (1).
•
Tighten the keyless chuck (1) onto the drill or driver bit as described above
(See Fig. 8).
DRILL OPERATION (cont.)
10
Fig. 6
Arrow
Fig. 7
Fig. 8
