HDR-710
3. CONTROLS CONT.
4. DRILLING
1 Depress and release the
variable speed switch to
ensure it is not locked on.
3 Secure the material to be drilled in a vice or clamp to stop it
turning whilst drilling.
4 Plug the hammer drill into the power supply.
5 Hold the drill firmly and place the bit at the point to be drilled.
2 Check the forward/reverse
lever for the correct setting.
Before connecting to a power supply, perform a few simple checks.
1 To set hammer mode, slide the selector to the hammer icon.
For drilling mode, slide to drill bit icon.
1 To set the drill to forward
rotation, push fwd/rev
lever hard right. For
reverse rotation, push
lever hard left.
6 Depress the variable speed
switch to start the drill.
7 Move the drill bit into the
workpiece.
Note:
Do not force the drill or apply side pressure to elongate the
hole. Let the drill do the work.
Fwd
Rev
1 For faster speed, rotate speed selection dial clockwise. For
slower speed, rotate dial anti-clockwise.
drill
hammer
Speed Selection Dial
Hammer Selector
Forward/Reverse Lever
Note:
Drill speed is reduced when in reverse.
NOTE:
ENSURE THE ON/OFF SWITCH IS
RELEASED AND THE DRILL HAS COMPLETELY
STOPPED ROTATING PRIOR TO CHANGING
MODES.
