HDR-001
4. STARTING THE DRILL
5. DRILLING
OPERATION
Note:
Do not force the drill or apply side pressure to elongate the hole.
Let the drill do the work.
WARNING!
THE POWER SUPPLY FOR THIS CHARGER IS
RECOMMENDED FOR USE WITH A RESIDUAL CURRENT
DEVICE (RATED AT 30mA OR LESS).
Variable Speed Trigger
1 To start drilling, squeeze the
variable speed trigger.
Note:
The more you press the
trigger, the faster the drill with
rotate.
2 To stop drilling, release the
variable speed trigger.
Lock-On Button
1 Squeeze the variable speed
trigger and then press the
lock-on button.
Note:
The variable speed trigger
can be released once the lock-on
button is pressed.
The hammer drill features a lock-on button to allow you to continue
operation without having to hold the variable speed trigger down.
2 To stop the drill,
press and release
the variable speed
trigger.
a
b
Pre-Operation Checks
Drilling
1 Depress and release the
variable speed switch to
ensure it is not locked on.
3 Ensure the material or work
piece is secure to stop it
turning whilst drilling.
1 Connect the hammer drill into
the power supply. Hold the drill
firmly and place the bit at the
point to be drilled.
Before connecting to a power supply, perform a few simple checks:
2 Check the
forward/reverse
lever is in the
correct setting.
2 Squeeze the
variable speed
trigger and move
the drill into the
work piece.
REV
FWD
