SETUP & PREPARATION
2. ASSEMBLY
WARNING!:
ENSURE THE TOOL IS DISCONNECTED
FROM THE POWER SUPPLY BEFORE ASSEMBLY
.
Fitting the Lower Handle to Mower Body
1. Fit the lower handle onto the
threaded ends.
1. First fit the cord retainer, slide
it over the upper handle end
before fixing the upper handle
to the lower handles.
1. Secure the power cord from the
switch housing to the mower using
cable ties (supplied).
2. To assemble the grass catcher
align the two halves and push
them together, one side at a
time. Ensure the two halves click
together around the entire middle
section.
1. Assemble the grass catcher
handle onto the opening
on the top half of the grass
catcher. The handle will click
into position when aligned
and fitted correctly.
WARNING!:
WHEN ASSEMBLING THE GRASS
CATCHER BACK TO THE MOWER AFTER
EMPTYING, ALWAYS ENSURE THERE IS NO BUILD
UP OF GRASS IN THE GRASS CHUTE. IF NEEDING TO
CLEAR THE GRASS, ALWAYS ENSURE THE MOWER
IS DISCONNECTED FROM THE POWER SUPPLY
PRIOR TO CLEARING. A BUILD UP OF GRASS IN THE
GRASS CHUTE MAY PREVENT GRASS FROM MOVING
INTO THE GRASS CATCHER EFFECTIVELY.
Securing the Power Cord to the Handles
Assembling the Grass Catcher
“CLICK”
“CLICK”
“CLICK”
Fitting and Removing Grass Catcher
Fitting the Upper Handle to the Lower Handle
3. To empty the grass catcher, lift
the catcher flap with one hand
then lift the grass catcher with
the other hand up off the two
raised housing clips.
The catcher must be attached to the two raised hooks on the mower.
1. Lift up the catcher flap with one
hand and guide the catcher over
the two hooks on the mower
housing.
2. Lower the grass catcher in place
and lower the catcher flap. The
catcher flap is held against the
gass catcher by a spring
2. Fit and secure in place with
the lower handle knobs.
2. Place the upper handle over
the upper ends of the lower
handle. From the handle
securing set, fit the bolts
through the inner side of
the lower handle and then
through the holes in the upper
handle. Secure in place by
screwing the handle securing
knobs over the protruding
ends of the bolts.
