7. RECOMMENDED SETUP cont.
Cleaning
Use a moist cloth to wipe down the pump housing. Allow to dry
thoroughly before storing in a dry location that is protected from bad
weather conditions.
Storage
If there is danger of frost, dismantle the device and accessories, clean
and store them in a place protected from frost.
Dismantle and store
1. Disconnect the device from the
mains supply.
2. Fully open any shut-off
mechanisms (spray nozzles,
valves, etc.) in the pressure
line so that the air can escape
without obstruction.
Note:
Ensure the gate valve on your
water tank is not left open as this will
allow water to drain from the tank.
3. Completely empty the pump by
unscrewing the water drain plug.
4. Dismantle the suction and pressure lines from the device.
5. Store device in a frost-free room
(at least 5 °C).
WARNING!
MAKE SURE THE PUMP IS DISCONNECTED
FROM ELECTRIC POWER SUPPLY BEFORE
PERFORMING MAINTENANCE PROCEDURES.
WARNING!
MAKE SURE THAT THE DEVICE AND
CONNECTED ACCESSORIES ARE DEPRESSURIZED
BEFORE CARRYING OUT ANY WORK ON THE DEVICE.
MAINTENANCE
CONNECTION WITH TANK BASE BELOW WATER PUMP
P
CONNECTION WITH TANK BASE ABOVE THE WATER PUMP
CONNECTION WITH TANK BASE LEVEL WITH WATER PUMP
FIRM BASE
SOLID STRUCTURE
WATERTANK
WATERTANK
NON-RETURN
VALVE
DISCHARGE
OUTLET
GATE
VALVE
GATE
VALVE
SUCTION LINE
SUCTION LINE
150mm
150mm
150mm
150mm
150mm
FIRM BASE
SOLID STRUCTURE
DISCHARGE
OUTLET
150mm
UNION
COUPLING
depending on
installation
UNION
COUPLING
depending on
installation
WATERTANK
GATE
VALVE
SUCTION LINE
SOLID STRUCTURE
DISCHARGE
OUTLET
FIRM BASE
UNION
COUPLING
depending on
installation
IN-LINE
FILTER
IN-LINE
FILTER
IN-LINE
FILTER
