2. GRINDING DISC FITMENT
3. ON/OFF SWITCH
1 Depress and hold the spindle
lock button.
3 Use the pin spanner to loosen
the outer flange.
5 Screw the outer flange onto
the spindle.
Note:
The flat side of the flange
locates against the disc.
Inspect the grinding disc before fitment to ensure it is not cracked or
deformed. The grinding disc is suitable for grinding tasks only. Only use
grinding discs with a diameter of 125mm.
2 Rotate the spindle to locate
the lock position.
4 Insert the disc with the label
facing up.
6 Depress and hold the spindle
lock button. Firmly tighten
the outer flange with the pin
spanner.
CAUTION:
REGULARLY CHECK THAT THE
OUTER FLANGE HAS NOT BECOME LOOSE
DURING OPERATION.
1 Press and hold the lock-off
button down.
2 Press the on/off trigger to start
the grinder.
3 To stop the grinder, release
the on/off trigger.
The angle grinder is fitted with a lock-off button to avoid accidental start
up.
WARNING:
THE TOOL IS RECOMMENDED FOR
USE WITH A RESIDUAL CURRENT DEVICE WITH A
RATED RESIDUAL CURRENT OF 30MA OR LESS.
