7. Use the above operation in reverse to remove grinding disc.
6. Depress and hold spindle
lock button. Firmly tighten
the outer flange with the
pin spanner.
2. GRINDING DISC
3. LOCK ON SLIDE SWITCH
3. Use pin spanner to loosen
the outer flange.
2. Rotate spindle to locate
the lock position.
1. To turn the grinder on, press the on/off switch forward
until it locks into place. The tool is now locked on for
continuous use.
2. To turn the grinder off, push down on the rear of the
switch.
CAUTION:
REGULARLY CHECK THAT THE OUTER
FLANGE HAS NOT BECOME LOOSE DURING
OPERATION.
OPERATION
The tool is recommended for use with a residual current
device with a rated residual current of 30mA or less.
Inspect the grinding disc before fitment to ensure it is not cracked
or deformed. The grinding disc is suitable for grinding tasks only.
Only use grinding discs with a diameter of 100mm.
1. Depress and hold
spindle lock button.
4. Insert the disc with the label
facing up.
5. Screw the outer flange onto the spindle.
Note:
the ring on the flange must locate within the hole on the
grinding disc.
