1
Changing The Inner Lens
If the metal bar is in place, follow Step 1 of Replacing The Outer Lens
to move it out of the way.
1. Using your nails or a flat ruler,
lift and remove the old inner
lens from its slot.
Note:
Try to avoid getting
fingerprints on the lenses.
2. Slide the replacement lens
back into the slot, ensuring
that all four corners of the lens
are securely under the corner
tabs.
Note:
Only one side of the inner
lens has a protective film on it.
Ensure this side faces towards
the inside of the helmet otherwise you will be unable to remove the
film once the lens is in place.
3. Remove the protective film from the inner lens.
4. Lower the metal bar back into
place. Pull it down and under
the tabs to lock the control unit
back into place.
Replacing The Outer Lens
Replacement lenses have been provided in case the original ones get
marked up during use.
1. On the inside of the helmet,
pull the metal bar down past
the tabs to release the control
panel unit.
2. Swivel the metal bar out of
the way.
2. Carefully lift the control
panel unit out of the way,
being careful not to touch or
scratch the UV/IR filter on the
underside of the control panel
unit.
3. Push down on the centre of
the outer lens from the inside.
This will allow you to squeeze
it past the tabs on the outside
of the helmet.
4. From the outside of the
helmet, slide one end of the
new outer lens into the groove
beneath the tabs. Gently push
down on the centre of the
lens from the inside and slide
it under the tab on the other
side of the panel.
6. Peel off the protective film from both sides of the outer lens.
7. On the inside, slide the control panel unit back into its seat.
ADWH-001
1. CHANGING THE LENSES
MAINTENANCE
Push Down
WARNING!
BE CAREFUL NOT TO SCRATCH THE
UV/IR FILTER AS THIS MAY IMPAIR THE AUTO-
DARKENING FUNCTION AND LEAD TO EYE
DAMAGE DURING USE.
