ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
1 Motor Housing
2 Overload Reset Button
3 Air Intake Filter
4 Tank
5 On/Off Switch
6 Pressure Regulating Knob
7 Transport Handle
8 Quick-Release Air Outlet
9 Wheel
10 Drain Valve
11 Support Foot
12 Safety Valve
13 Tank Pressure Gauge
14 Regulated Pressure Gauge
AIR COMPRESSOR
KNOW YOUR PRODUCT
1. ASSEMBLY
SETUP & PREPARATION
psi
bar
bar
psi
0
2
4
6
50
100
150
200
50
150
170
100
230
0
8
10
12
14
16
12
10
8
6
4
2
0
1.5 HP
8
MAXIMUM
BAR
24 LITRE
AIR COMPRESSOR
1 2 3
4
5 6 7 8
psi
bar
0
2
4
6
50
100
150
200
230
0
8
bar
psi
50
150
170
100
6
4
2
0
11
10
9
12
13
14
WARNING!
ENSURE THE TOOL IS SWITCHED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING PROCEDURES.
Pre-Setup Checks
Fitting the Wheels
• Examine the machine for signs of transit damage. If damaged, do
not use, contact Ozito.
• The compressor should be set up near the area of use.
• Avoid long air lines and long supply lines (extensions).
• Make sure the intake air is dry and dust-free.
• Do not set up the compressor in damp or wet rooms.
• The compressor may only be used in suitable rooms (with good
ventilation and an ambient temperature from 5°C to 40°C). There
must be no dust, acids, vapours, explosive gases or inflammable
gases in the room.
• The compressor is designed to be used in dry rooms. It is prohibited
to use the compressor in areas where work is conducted with
sprayed water. Before you use the machine, make sure that the
mains voltage complies with the specifications on the rating plate.
Note:
You must fully assemble the compressor before using it for the
first time.
1 Place a washer onto
wheel bolt and insert the
wheel bolt through the
hole in the wheel bracket,
below the tank.
2 From the inside of the
wheel bracket, place a
washer and spring washer
on the wheel bolt. Fasten
the wheel bolt in position
with a nut.
3 Repeat this process with the second wheel.
ACP-24151
