•
Always assume that the tool contains fasteners.
Careless handling of the
stapler can result in unexpected firing of fasteners and personal injury.
•
do not point the tool towards yourself or anyone nearby.
Unexpected
triggering will discharge the fastener causing an injury.
•
Do not actuate the tool unless the tool is placed firmly against the
workpiece.
If the tool is not in contact with the workpiece, the fastener may be
deflected away from your target.
•
disconnect the tool from the air supply when the fastener jams in the tool.
While removing a jammed fastener, the nailer or stapler may be accidentally
activated if it is connected to the air supply.
•
do not use this stapler for fastening electrical cables.
It is not designed
for electric cable installation and may damage the insulation of electric cables
thereby causing electric shock or fire hazards.
NAILER SAFETY WARNINGS
STAPLE/NAIL COMPATIBILITY
The RST-80S accepts staples with the below measurements
PLEASE NOTE: The RST-80S does not accept cable or
round “U” shaped nails. Only attempt to use staples with the
measurements outlined in this manual.
Note: All measurements are in mm.
WARNING!
Read all safety warnings and all instructions. failure to follow the warnings
and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference. The term “power tool” in the
warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power
tool.
1. Work area safety
a.
Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b.
Do not operate power tools in explosive atmospheres, such as in the presence of flammable
liquids, gases or dust.
Power tools create sparks which may ignite the dust or fumes.
c.
Keep children and bystanders away while operating a power tool.
Distractions can cause you to lose
control.
d.
dress properly. do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away
from moving parts.
Loose clothes, jewellery or long hair can be caught in moving parts.
e. Check the maximum pressure rating of any tools or accessories that you intend using with the
compressor. The output pressure of the air from the compressor must be regulated so that it never exceeds
the rated pressure of the tool or accessory.
f. Always wear safety goggles or glasses when using the air tools. Never point the nozzle of an accessory
towards any part of your body or towards another person.
g.
drain the moisture from the tank daily.
It will help prevent corrosion.
h. The tool must be used only for its prescribed purpose. Any use other than those mentioned in this Manual
will be considered a case of misuse. The user and not the manufacturer shall be liable for any damage or
injury resulting from such cases of misuse.
WARNING!
In the event that an air line is cut or broken, the air supply must be turned off at the
compressor. A broken air line which is not supported is extremely dangerous and can whip around
very quickly, both with the capability of striking people, and blowing foreign particles into the air.
•
Do not attempt to catch the air line but immediately keep bystanders well clear and turn off the air supply to
the hose, turn off the compressor at the On / Off button, and then remove the hose from the compressor.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given the supervision or
instruction concerning use of the appliance by a person responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance.
GENERAL AIR TOOL SAFETY WARNINGS
0.95
12.8
6-16
0.65
