![background image](http://html1.mh-extra.com/html/ozito/18v-li-ion/18v-li-ion_instruction-manual_1666813003.webp)
2. BATTERY & CHARGER
1. Plug the charger adaptor
Into a mains power outlet.
Charger LED will illuminate
green showing power is
being supplied
2. Fit charger connector.
CHARGED OK
CHARGING
This charger is recommended for use with a residual current
device with a rated residual current of 30mA or less.
Charging
Note:
Do not charge for more than 5 hours.
Installing and removing the battery
Slide the battery until it clicks
into place.
Hold down the battery release
button and slide the battery out.
2
1
3. POLE PRUNER PREPARATION
WARNING!:
Pole pruner comes from the factory
with no chain bar oil added. Oil level should also be
checked after every 15 minutes of use and refilled
as needed.
NOTE:
Only use oil that is expressly labelled
“CHAIN BAR OIL”.
1. Remove green chain bar oil cap and pour the chain oil into
the tank. Chain Bar Oil Tank Capacity: 60ml
Low
Full
2. Check and fill the oil tank
when oil line is low. Repeat as
needed.
Running in the chain
Prior to operation, a new chain should be run in for 2–3 minutes
and then it’s tension should be checked as the chain may
loosen slightly when warm. Make Adjustments as detailed in
“MAINTENANCE”
.
Chain bar oil
3. Charger LED will illuminate
red showing the battery is on
charge
CHARGED OK
CHARGING
CHARGED OK
CHARGING
4.
When fully charged, the LED
on the charger adaptor will
illuminate green.
Low
Full
3. Fasten the chain bar oil cap
and clean any oil spillage.
2