![background image](http://html.mh-extra.com/html/ozito/12v-dc/12v-dc_instruction-manual_1666393005.webp)
MAINTENANCE
DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
TROUBLESHOOTING
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
• Keep the ventilation vents of the impact wrench clean at all times, if possible,
prevent foreign matter from entering the vents.
• After each use, blow air through the impact wrench housing to ensure it is
free from all dust particles which may build up. Build up of dust particles may
cause the impact wrench to overheat and fail.
• If the enclosure of the impact wrench requires cleaning, do not use solvents
but a moist soft cloth only. Never let any liquid get inside the impact wrench;
never immerse any part of the impact wrench into a liquid.
• If the replacement of the supply cord is necessary, this has to be done by the
manufacturer or his agent in order to avoid a safety hazard.
Spare parts can be ordered from the Special Orders desk
at your local bunnings Warehouse.
for further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
ELECTRICAL SAFETY
Problem
Cause
Solution
Sparking visible
through the housing
vents
Small amounts of
sparking is normal
Not a problem
The impact wrench
does not start
Impact wrench not
connected to the power
Connect the 12V
socket to a 12V DC
outlet
Insufficient supply
voltage
Try another 12V
outlet
Fuse needs replacing
Replace Fuse
The impact wrench is
damaging the thread
or bolt head
Nut or bolt not pre
tightened
When tightening
nuts or bolts, first
tighten by hand
Socket not placed over
the bolt head properly
Ensure the correct
size socket is being
used and is place
over the bolt head
LED light wont turn
on
Impact wrench not
connected to the power
Plug the 12V socket
into a 12V outlet
Fuse may need
replacing
Replace 10A fuse
following the steps
in this manual
WARNING!
When using mains-powered tools, basic safety precautions,
including the following, should always be followed to reduce risk of fire, electric
shock, personal injury and material damage.
Read the whole manual carefully and make sure you know how to switch the tool off in an
emergency, before operating the tool.
Save these instructions and other documents supplied with this tool for future reference.
The electric motor has been designed for 12V only. Always check that the power supply
corresponds to the voltage on the rating plate.
If the supply cord is damaged, it must be replaced by an electrician or a power tool repairer in
order to avoid a hazard.
V
Hz
~
W
/min
Volts
Alternating current
Revolutions or
reciprocation per minute
Warning
Hertz
Watts
No load speed
Diameter
n
Regulator compliance mark
Read instruction manual
Wear eye protection
Wear ear protection