Oz-View Wireless video intercom, Technical Manual

Page: 8 / 20

Oz-View Technical Manual V1.02 - 1
st
Jan 2011 8
Button description
“ON/OFF” button: It is used to power on/power off of wireless handset monitor.
“ ”: Is used to: a) answer the calls when visitors press the call button on the
outdoor call station; b) as the confirmation button when performing the ringing
tone selection; c) as the coding button when carrying out coding between the
components.
“ ”: In standby status, it is used to enter the menus of ringing tone
selections; in talk status, it is used to increase brightness.
“ — ”: In talk status, it is used for reducing brightness.
“ ”: Is used to switch on the camera in outdoor call station in order to view
outside in standby status.
“ ”: It is used to operate an electric lock release when the monitor is in the
“talking” status.
“ ”: Is used to clear the previous code. After this operation, you should carry
out the coding procedure between or among the call stations and handsets
again.
“ ”: Is used to set/unset the mute features.
ID NO. display
Press and hold the “ON/OFF” button when the handset monitor is in the OFF
status, until the 2.4 inch TFT-LCD displays “Welcome” and sounds two “Di
Di” tones, then release the button. It means that the handset monitor is
entering into the ON status.
Press and hold the “ON/OFF” button when the handset monitor is in ON status,
then the 2.4 inch TFT-LCD will show “Goodbye” and create two “Di Di” tones,
then release the button. This indicates that the handset monitor is entering into
OFF status.
When the outdoor camera is powered, a single “Di” tone indicates that call
station 1 is being viewed. If a dual “Di Di” tone is sounded, this confirms that
the call station 2 is being viewed.
Coding
Note: When the system is purchased as a kit, the handset and call station
have been coded together at the factory.
1).Press the “ ” and “ ” buttons at the same time when the handset
monitor is in power-on status, until the screen shows the letters “Configure
code”, then release the buttons and it will enter the coding status.
2).At this time, press the call button in outdoor camera when it is in standby
status until the red indicator remains lit and creates two sounds “Di Di”, then
release the button and it will enter the coding status.
3).If the handset monitor shows the letters “success” within 8s, the coding is