Oxford Oximiser 3X, User Manual, Page: 2 / 56

2
GB
Oximiser 3X User Manual
IMPORTANT SAFETY INSTRUCTIONS
*SAVE THESE INSTRUCTIONS*
1. KEEP THESE INSTRUCTIONS – This manual contains important safety and operating instructions for battery
charger Model: Oximiser3X.
2. Do not expose this charger to rain or snow and do not use outside under a motorcycle cover.
For indoor operating use only.
3. Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of
fire, electric shock, or injury to persons.
4. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger.
5. An extension cord should not be used unless absolutely necessary. Use of improper extension cord could
result in a risk of fire and electric shock. If an extension cord must be used, make sure:
a) That pins on plug of extension cord are the same number, size, and shape as those of plug on charger;
b) That extension cord is properly wired and in good electrical condition; and
c) That wire size is large enough for ac ampere rating of charger.
6. Do not operate charger with damaged cord or plug – replace the cord or plug immediately.
7. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take
it to a qualified serviceman. Please note that Oxford Products are unable to offer this facility. If the charger
case is opened it will invalidate the Oxford Products guarantee
8. Do not disassemble charger; take it to a qualified serviceman when service or repair is required. Incorrect
reassembly may result in a risk of electric shock or fire.
9. To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning.
Turning off controls will not reduce this risk.
10. This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.
11. Children shall not play with the appliance.
12. Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction concerning use of the appliance in
a safe way and if they understand the hazards involved.
**** This product is designed for use with Lead acid and MF batteries between 4 and 125 Ah capacity****
Introduction
The OXIMISER3X is a professional switch mode charger designed to automatically maintain, optimise and
therefore prolong the life of a 12-volt battery.
Battery size
(Amps/Hr)
Mode
Typical
charge time
(hrs)
1.5 2.5
7 11.0
10 16.0
14 3.5
20 5.5
36 10
50 14.0
80 22.0
100 27.0
125 34.0
Mode Battery type
Lithium
(LiFePo4)
batteries
14.4V / 0.8A
For batteries under 36Ah.
14.4V / 3.6A
A common charge rate for
Lead Acid, MF and GEL
batteries.
14.7V / 3.6A
Suitable for charging AGM
batteries that require a
higher charge voltage.
Especially useful for charging
batteries in freezing weather.
N/A
To charge Lithium batteries
we recommend to seek advice
from the battery supplier
before charging. ONLY use the
Motorcycle or Car charging
modes.
DO NOT use the mode
because it will charge at a
voltage too high for Lithium
and may damage the
battery.