Version 1.4 rev 13 Oct 2017
18
Newton
SECTION 3:
INSTALLATION
WARNINGS:
• PRIOR TO COMMENCING INSTALLATION, THE USER SHOULD REFER TO THE SAFETY AND WARNING
INFORMATION AND UNPACKING INSTRUCTIONS AT THE BEGINNING OF THIS MANUAL.
• CABLES SHOULD BE ROUTED TO PREVENT ACCIDENTS, DAMAGE AND ACCIDENTAL UNPLUGGING WHILE
AVOIDING BEND RADII OF LESS THAN 30 MM.
• FOR FURTHER INFORMATION ON SO AND SY MODELS PLEASE REFER TO SECTION 5.
• TEMPERATURE AND HUMIDITY MUST MEET THE SPECIFICATIONS DEFINED IN TECHNICAL SPECIFICATIONS.
3.1 t
RanspoRt
and
s
toRage
i
nfoRMation
• Storage Temperature: -30°C to 50°C.
• If it is to be stored after use at a temperature below the coolant freezing point, ensure that all liquid coolant has been
expelled from the camera.
3.2 M
oUnting
tHe
n
eWton
Using
tHe
M
oUnting
f
lange
The standard Newton mounting flange has mounting holes for 4x M4 fittings. For further information, refer to the
mechanical drawings in
Appendix B
. For SO models refer to
Section 5
.
3.3 a
ttacHing
to
M
oUnting
p
osts
There are three holes that can be used if required with the 1/4 - UNC mounting posts with 1” spacing.
For further information, refer to the mechanical drawings in
Appendix B
.
3.4 c-
MoUnt
An optional C-mount adapter is available for standard Newton models.
3.5 c
onnecting
tHe
n
eWton
to
tHe
pc
The appropriate PCIe card should be available in the control PC.
USB 2.0
•
Connect the USB 2.0 cable from the Newton to a suitable USB 2.0 slot on the control PC.
