Step 1
On a clean flat surface, lay right arm assembly 1 on its side
mortise holes facing up. Place the back 3 into the mortise
of the right arm assembly.
Step 3
Line up and place left leg assembly 2 onto those parts
NOTE: Insert the tapered end of the dowels first.
already assembled.
Step 2
Locate the small label on the bottom of the seat that reads “front”.
With the front of the seat toward the front of the bench, line up
and insert the front rail 5 and seat 4 into the right arm assembly.
Insert the large rounded pegs at the front and rear of the seat into
the back and front rail.
Step 5
Step 4
detail
Using a phillips head screwdriver, screw the 8 wood
screws
B
into the predrilled holes on the underside of
the seat to attach the seat to the seat back, front rail and
arm assemblies as shown.
Assembly Instructions
page 2
Chadwick - 5' Swing
A
2
4
3
A
1
Step 4
With a hammer, drive 4 dowels
A
into the predrilled holes found
on the front of the arm assemblies to hold the front rail into place.
Drive the remaining 8 dowels into the predrilled holes located on
the back of the arm assemblies to hold the back in place.
4
5
A
A
A
A
A
1
3
4
5
2
B
B
B
B
B
B
B
B
