1.Safety Information
If the reading exceeds 55 MΩ in 50 MΩ range, "overload" will be displayed.
4. Set the measurement speed.
Press the Speed softkey to switch between Low, Mid and High. See page 14,
Measurement Speed .
5. Set the relative value.
Press the Rel softkey to turn on or off the relative operation. For relative
operation, the multimeter subtracts the pre-specified value of REL operation
from the actual measurement result and displays the result. See page 29,
Relative Value.
Tip:
If the measured resistance is small, relative operation is recommended in
order to reduce the error caused by test lead.
Both ends of the measured resistance should be placed far away from your
hands and desks that can conduct electricity; otherwise, the measurement
result might be inaccurate. The greater the measured resistance is, the
greater the affect will be.
Continuity Test
This section describes how to configure continuity test.
Operating Steps:
1. Enable the continuity test.
Press
on the front panel, press it again to enter continuity test mode.
2. Connect the test lead.
20
