5.Front Panel Operation
Figure 5-10: The User Interface of Noise Signal
To Output Arbitrary Signals
Press
button to call the user interface of Arbitrary signal, the Arbitrary waveform
parameters can be set by operating the Arbitrary setting menu on the right.
The parameters of Arbitrary waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level, Built-in Waveform. You can operate the menu by using the menu
selection buttons on the right.
To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to "
To
Output Sine Signals
" on P11.
The frequency range is 1
μ
Hz
~
10MHz; the period range is 100ns
~
1Ms.
The Arbitrary signal consists of two types: the system built-in waveform and the
user-definable waveform.
Parameter bar 1
Setting menu of
Arbitrary signal
Amplitude
Load
Offset
Parameter bar 2
Current signal
Frequency
Current parameter
Built-in Exponential
Rise Waveform
Figure 5-11: The User Interface of Arbitrary Signal
To Select the Built-in Waveform
Press
button, then press
F4
to enter the
Built-in Wform
menu.
There are three built-in Arbitrary waveforms: Exponential Rise, Exponential Fall, sin(x)/x.
The Exponential Rise waveform is shown in the figure above (
Figure 5-11
). The
Exponential Fall and sin(x)/x waveform are shown in the figure below.
18