3
INTRODUCTION
PRECAUTIONS
Safety
- Exercise caution when working with any optical equipment. High-intensity fiber optic laser sources output potentially
dangerous high energy invisible light, and could cause serious, irreparable damage to the eye. Thus, it is recommended to
look into the connector port of a light source or the end of a fiber.
Operational
- It is important to keep connector ferrules and optical connector ports clean. If dirt, dust, and oil are allowed to build
up inside connector ports, irreparable damage may occur to the optics inside the port. For best results, replace dust caps after
each use.
Connector
- if you have the optional Visual Fault Locator installed, do NOT insert APC (Angled Physical Contact) connectors into
the VFL port on your WaveTester as this may damage the angled ferrule on the APC connector.
NEVER
On the back of each WaveTester series optical power meter is a label similar to the one shown below containing model number,
serial number, power requirements, and special cautionary information. If the unit is enclosed in its protective boot, the boot must
be removed to view this label.
PRODUCT LABEL
Optical Wavelength Laboratories
Whitewater, WI 53190 (262) 473-0643
MODEL# WT-1
SERIAL# WT11019
POWER: 5V DC
MADE IN USA
Conforms to the Harmonized European
Standards EN 61326-1 and EN 61010-1.
Visible Optical Radiation When
VFL Is Set To The ON
Position -- Avoid Eye
Exposure To Direct Radiation
IEC 60825-1
Red Laser: 650 nm ~ 0 dBm
CAUTION: If optional VFL is installed:
Optical Wavelength Laboratories
Whitewater, WI 53190 (262) 473-0643
MODEL# WT-1V
SERIAL# WT81019
POWER: 9V DC
MADE IN USA
Conforms to the Harmonized European
Standards EN 61326-1 and EN 61010-1.
Visible Optical Radiation When
VFL Is Set To The ON
Position -- Avoid Eye
Exposure To Direct Radiation
IEC 60825-1
Red Laser: 650 nm ~ 0 dBm
CAUTION: If optional VFL is installed:
