Face Rest Set-up
(cont):
- Replace the Face Rest Cushion on the QuickLock
™
Face
Rest Frame.
Note: The Crescent Face Cushion can also be adjusted for larger
or smaller faces by flexing the ends of the crescent pad closer
together or farther apart. Hold the cushion in the desired
position and place it on the Velcro
®
brand hook & loop fasteners
of the face plate to secure the adjusted position.
- Slide the face rest dowels into the chair’s connector tubes
on the Seated Support Frame.
- Hand-tighten the knobs to hold the face rest in place.
NOTE: Please make sure that the teeth on the cam locks
are meshed between each other. Do not allow the teeth
to grind against each other.
You are now ready to proceed with custom fitting the Face
Rest to suit you comfortably.
• Sit on the chair.
• Release the cam locks
(Fig. 11)
and loosen the knobs.
(Fig. 12)
• Hold onto the face rest on the Velcro
®
brand hook & loop
fasteners on the sides of the U-tube.
(Fig. 13)
• Pull the face rest toward you until your forehead rests
comfortably on the cushion and tilt your head until you are
looking straight down at the floor.
(Fig. 14)
• Lock the cam locks
(Fig. 15)
and tighten the knobs.
Please do not over tighten as too much force may cause
stripping. Be sure that the teeth on the cam locks are meshed
between each other. Do not allow the teeth to grind against
each other.
Setting-Up and Using the 3-Pad Face Cushion:
• Take the Crescent Face Cushion off the QuickLock
™
Face Rest
Platform by pulling it off the Velcro
®
brand hook & loop fasteners.
• Place the 3-Pad face Rest Plate onto the platform. It will attach on
the Velcro
®
brand hook & loop fasteners.
(Fig. 16)
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
pg 5
Velcro™
