Press the yellow switch button beside the tracker with a tool, the SIM card holder will come out.
Pull it out and put the SIM card in the holder and then push the holder into the tracker again is OK
(Pay attention to that the SIM card metal contact pin can not face down to the holder).
.
SIM Card Release(Press)
Sim Card Metal Pin Face to Up
Note: 1. This tracker use 2G GSM & 3G WCDMA network, and it upload information by internet, it
can not work in CDMA network or CDMA2000 network. (Some 4G SIM card can use in
3G WCDMA or 2G GSM network, this kind of 4G SIM card can be used in this tracker)
2. Please confirm the PIN code of the SIM card is disabled (insert the SIM card to mobile
phone and can be disabled in mobile phone setting menu).
3. Before installing or uninstalling the SIM card, please power off the tracker.
3. ANTENNA
The Antenna of GSM and GPS are built in the tracker.
Big metal and car panel will reduce the GSM and GPS signal. the GPS antenna need faced to
heaven, otherwise the GPS signal will be weak and maybe can not located, if can not locate
insert to OBD interface, you need connect a OBD wire to install the tracker to other place .
4. Using Condition
The working temperature is -20
0
C to 60
0
C, over this range the specification maybe can not
reach the standard level, the storage temperature can reach to -40
0
C to 80
0
C.
5. Back to factory setting (Default configuration)
Sending SMS (factory*123456) to the tracker will delete all user setting and back to factory
configuration and repower on.
Notes: After back to default set, all IP / APN / GPRS / Language / Timezone / Alarm Setting
etc are deleted and back to factory setting, just like a new product, all authorized phone
number are deleted and password change to 123456, all the alarm setting is canceled, if the
-3-
Summary of Contents for PL630
Page 17: ......
