Aircraft shielding installation method:
Pay attention to
The protective hood and the blade should be
assembled as per the two direction of A, B
indicated. Please note that the protective
hood of the aircraft should be correctly loaded
as per the correct loading position shown,
which is corresponding to the picture above.
Please DO NOT load it wrong.
Step 1: Please pull out the decoration piece
of the 4 protective hoods as the left picture
shown and well keep it.
Step 2: As the left
picture shown, please insert the protective
hood into the groove as per the correct
position shown.
Step 3: As the left
picture shown, lock the screw included into
the hole position of the two screws.
Following the same method to load the
other 3 protective hoods, please load and
well lock the screws as the correct position
shown, thus finish the assembly.
Battery installation
1. As the picture shown, please unload battery
cover of the transmitter. Load 4 PCS “AA”
batteries (not included) as the correct
polarity shown in the battery compartment,
and then load the battery cover and tightly
wrench the screw.
Caution: a. When loading batteries, please load the
batteries as per the correct “+” “-“ polarity shown
on the battery compartment. Please DO NOT load
them upside down.
b. Please DO NOT mix using the old batteries with
the new ones or mix batteries of different types of
brand.
A shielding
B shielding
B shielding
A shielding
A the blades
A the blades
B the blades
B the blades