Overmax X-bee drone 5.1, User Manual

Page: 6 / 59

5. TRANSMITTER - RECEIVER SYNCHRONIZATION AND CALIBRATION
Step 1
Switch the controller's power button to "ON" position. The LCD display turns on and the LED starts to blink.
Push the throttle stick from the lowest to the highest position, and then push it back to the lowest position.
The LED starts to glow steadily, then blinks.
Step 2
Turn on the drone using the switch located on the underside by
moving it to "ON" position. The quadrocopter's lights switch on.
The controller emits a beep sound indicating correct
synchronization with the receiver and the LED starts to glow
steadily. Place the drone on a flat surface to ensure the
gyroscope is centered. Do not move the drone during the
synchronization process.
Step 3
To calibrate, move the direction stick to the bottom right corner and wait
until the drone's LEDs stop to blink. Now, the calibrated drone is ready to
fly.
Step 4
After the flight, move the controller's switch to "OFF" position (the power LED and the display go off). Then,
power off the drone using the same method - move the power switch located on the bottom of the drone to
"OFF" position. The lights will go off indicating that all the systems are off.
6. OPERATING THE DRONE
Flying up / down
Move the throttle stick forward
to fly the drone up.
Move the throttle stick
backward to fly the drone
down.
Rotating left/ right
Move the throttle stick left /
right to rotate the drone in a
given direction.