2 - 7 ...Pair a In-Ear
To pair a In-Ear to the Beltpack, you need to go into the «Connect IE» menu.
Once you confi rm this choice the Beltpack will connect itself to the nearest In-Ear.
Note :
- The In-Ear needs to be in «discoverable» mode (See In-Ear User Manual).
- The Beltpack can transmit an audio stream to two In-Ears at a time. The two In-Ears must be paired
during their fi rst use. This will be done automatically (See In-Ear User Manual).
Connect IE
Menu
SET
2 - 8 ...Activate Eco mode
Eco mode allows the optimization of the In-Ear battery’s life.
The principle is to stop the stream between the In-Ear and the Beltpack when no signals are transmitted
from the Beltpacks. A calibration of the noise threshold is done automatically at each activation of the
Eco mode.
The key «Calibrate» allows you to redo a new calibration.
You must perform the calibration during a ambiant silence, or else you will have to redo the calibration
procedure.
Eco Mode
Menu
SET
Eco Mode
SET
Enable
Back
Calibrate
2 - 6 ...Change the channel used by the Beltpack
From the Beltpack, you can change the channel on which the TX-Box was associated to by default during
the initial connection.
To do this you must access the «Channel» menu.
Menu
OK
< Ch 8 >
+
-
Channel
Menu
SET
Overline-Systems - www-digitear.eu - [email protected]
USER GUIDE Beltpack
Page 5/19
